700 LE Tail pushrod link on bell crank rubbing

[aseejr]

On my 700LE build. The tail pushrod linkage that is snapped on the bellcrank is rubbing against the boom block. And if the fitting is turned a certain way it will actually bind. ?

I've also been searching for a setup video for the Align flybarless system. Is there one?

Thanks,

Albert

[glen09]

I have just come across this problem this week on my 700 build, I just turned the ball link to the bottom of the bell crank. Its don't look quite right but it works!

As for fbl setup just google bert kammerer align 3g setup.

[mlucia]

On my 700LE build. The tail pushrod linkage that is snapped on the bellcrank is rubbing against the boom block. And if the fitting is turned a certain way it will actually bind. ?

I've also been searching for a setup video for the Align flybarless system. Is there one?

Thanks,

Albert

Make sure you have the frame mounting block for the tail control arm in the correct orientation. If you have it turned 'in' the control arm will rub. Look carefully at the diagram in the manual.

Bert has a 3g setup vid here: http://www.bertrc.com/archives/458

[aseejr]

Thank you. That fixed it. My error in installing the bellcrank block.

Thanks again,

Albert