How do I lower the roto head ?

[Clean]

When i connect the battery to the heli the rotor head jumps too high is there a way to fix it lower it a bit ?

[slider46]

Make sure all the servo arms are straight and level with the bench, if not fix them first. Then you can shorten the rods from the servos to the swashplate, until everything is where you want it. Before doing this next step, unplug both motor from the 4in1 unit, then arm it. You will have to reset your pitch all over again to make sure you have -10 to +10 degrees pitch and that you have 0* pitch at mid stick in idle up.... Take your time and it will all come together once you get the pitch set right

[Clean]

Thank you ill try it but its hard for me to understand because i am new to rc helis. :(

[slider46]

Go to blade cp repair.com they should have a detailed article about setting pitch etc on there site....

[Clean]

Ok thanks.