jw637362
05-02-2010, 11:07 AM
I replaced the plastic fan with an Aluminum upgrade on my Raptor. When I installed my Magnets. I in-advertantly installed them both Positive side Down toward sensor.
I know that Some Governors, throttle jockeys etc need to have 1 positive polarity down and 1 neg polarity down so it does not read them both and thrash the settings.
I have the Futaba GV-1 and when I rotate it, I am getting Sensor reading on the pickup magnet of 97% and then the other comes around and it only registers 4 - 5%. I believe this govenor is only reading the one magnet but the book states to mount the opposite balancer magnet with opposite polarity.
Should I need to dismantle this thing and drill it out to put in opposite way.
Thank you[8|]
I know that Some Governors, throttle jockeys etc need to have 1 positive polarity down and 1 neg polarity down so it does not read them both and thrash the settings.
I have the Futaba GV-1 and when I rotate it, I am getting Sensor reading on the pickup magnet of 97% and then the other comes around and it only registers 4 - 5%. I believe this govenor is only reading the one magnet but the book states to mount the opposite balancer magnet with opposite polarity.
Should I need to dismantle this thing and drill it out to put in opposite way.
Thank you[8|]