View Full Version : Cheap one ways in the UK?
I'm tired of spending £5 for one-way bearings that fail for no apparent reason, or even for crashes where throttle-hold was already applied...
I gather the EXI 250 bearing will work with the t-rex 250, but I can't find any vendors in the UK. Anybody know of any sources here?
altascape
05-08-2010, 05:13 AM
The Trex 250 oneway bearing is weak and expensive. Never found any alternative in the UK. I use these
http://hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=10231
I ve never had a problem with delivery from HobbyKing (to UK)
exit44rc
05-10-2010, 07:38 AM
Do you know if you can just buy the bearing by itself ( http://hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=10251&Product_Name=HK-250GT_One-way_Bearing ) and press it into the gear on the trex 250se?
Aha! That's exactly what I was looking for. But other places I found it wouldn't say in advance how much the postage cost.
Thank you both.
makmov
05-10-2010, 02:37 PM
I think the bearing for the clones and the Trex are the same. The bearing holding and gear set are different so you cannot mix and match a clone holder with an Align gear set or vis-versa. You can use one or the other whole assembley, but the one-way is the same.
It is I just pulled a bunch of dead ones out of clone and Align holders.
I don't know about the SE.
makmov
05-10-2010, 02:44 PM
Aha! That's exactly what I was looking for. But other places I found it wouldn't say in advance how much the postage cost.
Thank you both.
They have Germany wearhouse. I don't think it would be too much to ship from there.