Gear Gap

[Speed_Freak_039A]

Is there any way to set the gear gap between the clutch and the main drive gear on the Raptor .30? All the motor mount holes seem to be round and have pretty much no play. besides the start shaft that has the clutch bell on it is in a set spot on the frame. The bearings are in cavities on the frame.

[Eric Lis]

usually not much movement. piece of paper between the gears and try to align. The motor to motor mount has a little room to play with. Don`t usually have to open any holes. Just patience...Good Luck

[zflarez]

THe gear gap is already set but the thing to check is the alignment between the clutch bell and the clutch. Everything should be straight up and down or you will be breaking clutches.

[Speed_Freak_039A]

O, Thankx guys.

[BarracudaHockey]

Spin the start shaft backwards, if theres drag on it the clutch to start shaft alignment is good.