Stinger 90 is to slow on pitch....what can i do?

[Makis]

Hy... :mrgreen:


i have a Stinger 90 with Webra 91 P5 engine and a Magic Pipe 91 muffler...

My servos are Futaba S9252 on all funktions.
At my engine i have a Futaba S3152...(slower)...


what can i do to make the Stinger 90 a little bit faster on pitch??

he is slower than my Raptor 50.... :? (on pitch) :arggg:


Thx for the help....


greatings from Stuttgart... :glasses2:

Makis

[flyinfool]

What pitches, headspeed and gear ratio are you running now?

When you say it is to slow on pitch, are you referring to the for/aft cyclic or the response to a collective input?

[Makis]

when i pitch the stinger up and down and up and down it is to slow.....he need a long time to change the from up to down...

sorry for my english :arggg:

[heliengineering]

Hi Makis:

verify that your main head linkages move free and washout phase ring alignment (two dowel pins) are correct. If these dowels are mis-align the pich up and down movement are tight and slow. Test them manually (remove links from servos). Also verify your blade grips free movement (remove the main blades for test them), many times when spindle screws, new dampers or bearings are installed can cause issues and overtight cause slow pitch movement.

regards

"don't worry my english its worst"... :wink:

[Makis]

ok....thank you...


i haved ordered one edge dampers with 90 durometer!
i hope they make my stinger faster!

the orig. dampers are really soft...

bye

[WJackson]

By faster on pitch i guess you mean punch out? If thats the case I would suggest putting a higher speed servo on the throttle I like all my machines to have a faster throttle responce than the pitch, try switching the two and see what that does. My .02.