Need help with g410t gyro on my 450xl

[shanea1]

Hi can someone help me .I am trying to setup my gyro on my 450xl I put a hitec 50 servo on my tail when I set the gyro to hh it move's in one direction and after only a little time it burn't it out . Do I need a digital servo ? can I put a Hitec 65 mg one on ? :( When its not in HH it stays in the center :shock:

[spork]

You don't necessarily need a digital servo on the tail. But you shouldn't set the gyro for digital if you use an analog servo. In HH mode it's important that you keep the heli perfectly stationary while the gyro initializes - and even then don't expect it to act like a "regular" gyro (it will not naturally center well with the heli sitting still).

[chooch]

Somthing to check also is the travel limit on the tail servo in both directions
as if it binds in one or either direction it will also cause your servo to fail.

[shanea1]

Thank, I didn't relize you can set your gyro to digital or analog but I'm a new to heli . Is there away to set it on the gyro or controller.

Thanks :dontknow

[spork]

I didn't relize you can set your gyro to digital or analog but I'm a new to heli . Is there away to set it on the gyro or controller.

See the attached pic. The switch in the upper-left corner is the "digital servo" switch. It should be off if you are using a regular servo.

[shanea1]

Here is mine

http://img299.imageshack.us/img299/452/twogj6.jpg


http://img299.imageshack.us/img299/2084/oneas4.jpg

:shock: Sorry but my one is JR g410T not g401 That's why I can't find the switch to turn it from analog to digital

Thanks anyway :arggg:

[spork]

I'm sorry - I was in brain-dead mode. I don't really know anything about that model :roll:

[shanea1]

That's OK :D