DS-760,and hard stops

[silverbullet]

Which parameters i should adjust ,if i want hard stops when flying piro manouvers.
is this the one?
(Clockwise stop gain and Counter clockwise stop gain)?

and is this also the way for the new Quark? very nice Gyro, but the stops are kind of to soft.

Thanks!

[TheBum]

Deceleration is what determines how fast the tail stops. Stop gain will allow you get clean stops without bouncing. You'll probably have to mess with both until you get fast stops with no bounce. A low stop gain may mimic a low deceleration.

[mmarian]

It is a little bit of a black magic, I am afraid. All the adjustments are intertwined, from my experience anyway.I mean the Accel and Decel, the CCW and CW stop gain and the Tx gyro % gain. I took me a very long time and heaps of experimenting until I found the combination of all above mentioned parameters to get he feel I was after. I keep in my comp most of the previous settings with a note of what was good and what was bad. In that case I can always go back to that point and start from there if I feel that I want to change the way the tail behaves. My advice is, do not be afraid to experiment. The CW and CCW stop gains could be quite different. The reason for this is that the motor torque pushes the tail in one direction. To make the tail stop the same way in both direction, naturally these two parameters need to take this fact into account. Good luck;)

[silverbullet]

Cool i will try out then.
Many thanks Guys!