Align 610 on 6.8v

[Global K]

Dear All,

I just changed to Reactor X2... throught of using 6.8v for the Align 610 cyclic anyone try 6.8v on 610 ??

Any improvement on 6.8v ?

thank you

[nitro burner]

I don't know about 610s on 6.8v but there is a big improvemen at 8v. :YeaBaby:

[IrishT]

+1 on 8v. They are running well for me.

[Global K]

8v :wow2::wow2:

?? the spec of the servo shows 6v the most !!

Running at 8v :wow2: won't it hurt the servo ?

Using Reactor X2 ??

[nitro burner]

No thay like it :Bang
Been running a set of 610s on one of my 600n's for over a year now on 8v.

[face992]

Lol nice, maybe I'll try this too. What type of lipo do you use? Do you recharge it after a certain number of flight to be sure it always have 8V minimum?

[nitro burner]

This setup has worked for me and I'm very happy with it, What i'm running is the 4.8v - 8.5v CCPM Adjustable Voltage Regulator from perfectregulator here the link http://www.perfectregulators.com/index.php?route=product/product&path=37_38&product_id=50
With my setup I run a 3 cell LiPo works great and keeps the amps to the the three swashplate servos at 10 amps and you get more flights on the battery as well.

[spike5150]

6.8V REGULATED is the "Same" as using a 5 cell rx pack, aka 6V.

Servos,etc that are 4.8V rated can usually be run at 6.0V REGULATED since a charged 4 cell pack is about 6V initially.

[Helico-pteron]

Dear All,

I just changed to Reactor X2... throught of using 6.8v for the Align 610 cyclic anyone try 6.8v on 610 ??

Any improvement on 6.8v ?

thank you
If you take the time to read the manual you will see that it says to put 4.8V servos on the 6V setting and 6V servos on the 6.8V setting.

You would not have to waste forum space for this question if you did read it.;)

That being said, 610s run up to 8.4V with out issues.

Page 2, step 3.
http://www.scottgrayrc.com/ReactorX%20Manual.pdf

Have a nice day.