611 SERIUS PROBLEM

[BarracudaHockey]

Thats normal there's nothing to fix.

Ask yourself this: Is the crash damage going to cost more than replacing the servo?

[MrMel]

when i was moving the Rudder Stick at home very fast at one point on the LCD there was "----" what is this and why does it happen , how do i fix it?


If it starts to say - HELLO - during movement, then you having a problem (bad RX battery etc).

As other has stated, replace the servo, lower the gain, run on regulated power, or at least a stepdown module for the servo.

[Krister T]

I had a similar problem on one of my new 611 gyros in my Black Shark3.
In ff did the heli starts to piruetting. The strange thing was that I hade some control of the gyro, the piruetting speed were in beetwen ridiculas high and extremely high :shock: .

Later on the bench so could I see how much input I had on the servo it was about 10deg on the servo arm stucked to one side with full movement on the stick.

This gyro was new and had only 4 flights. I run on high gain as I fly F3c just as David H. I'm using 4.8v nicad.

After switching on and off the gyro so did it work normaly as it should do.
Futaba told me that the gyro sensor was the problem and they sent me a new one.

Krister T

[DavidH]

Good to hear from you Krister. Hope everything is going well for you and your family. Hope to see you in Poland at the WC's.

David

[fgcity]

i appriciate all the help guys, i hope this doesn't happen to me again.