2610 Channel change.

[jingles]

Hi, evereryone.
Suddenly found myself the new owner of an ARK450. Needed a transmitter to go with it so got a 2610 from one of the UK's dealers.
Have found that the left stick was set up as the throttle stick with the ratchet that side.
Have changed the ratchet to the right stick but this still leaves me with the problem of needing to re-assign the channels as the left stick is still seen as the throttle. Spent hours reading the manual but to my inexperienced eye cannot find anything.
Can anyone out there help please.
The dealer is closed on Wednesdays and I'm off to the North Sea tomorrow (no internet) for four weeks and would like to get this sorted, if possible, before I go. Then I can practice on the Simulator while away.
Many thanks in advance for any advice.

[Pinecone]

Of course over here we fly with the throttle on the left stick. :)

Problem is, if you fly a CCPM machine, the mixing is programmed for channels 2, 3, and 6. Throttle is Ch 1 (this for JR). So even if you swap the servo plugs, the mix won't be right.

If you fly mechanical mixing, you would swap the servos plugged into 1 and 2 (IIRC).