RAZOR with HV85 Settings

[Clintstone]

This is a starting point. The great part is that it can be tweaked for personal preference.
--------------------------------------------------------------------------------

Shawn, these are the settings for the Razor with HV85. I am using a 14mz and the throttle value on Throttle Curve are as follows. 37 - 1700, 40-1860, 45-1975. I am flying the HS at 1975 with the tango 45-08 and I am getting 6 min no problem and I can stretch the flight but at 6 min. I have great power and I am not getting in trouble with taking the packs too low. Depending on flying style you could easily see 6 to 7 min. with the 3700's. I always recomend starting with a shorter flight and then extending according to what your style will allow. Use the 80% rule and you will be fine.

Will and I setup his Ion on the phone with my ion settings and my 14 setting and we will see if he has the same result as me. He should fly it today so he will add feedback asap. The 85 is working well and everything has been very consistant. I am very pleased wuith the results.



################################################## #####
# Castle Link Data File
# Created: Sunday, December 03, 2006
# Do Not Edit This File By Hand
################################################## #####
Brake Ramp: Super Slow
Cutoff Voltage: 180
Hex55: 85
Brake Strength: 0
Direction: Forward (*)
Spool-Up Speed: 6
Throttle Type: Heli: Governor High
Current Limiting: Disabled
Brake Delay: No Delay
Motor Start Power: 2.125
Throttle Response: 2
Motor Timing: Standard Advance (*)
Cutoff Type: Soft Cutoff
PWM Rate: 13khz (*)
Governor Gain: 24.2857142857143
_________________
Clintstone

[Clintstone]

To add to the above, I am running the 319 rx and the 611 gyro with a 1500 FP TX pack with a duralite regulator. I am running 9252's on the swash. I have 600 v-blades and 95 tails with 85 paddles.

[NolanManley]

I was calling Will Sparky but I can see that your the real Sparky. Great info on this ESC and the 110.

Thanks Clint.

I have got to get over your way again as it's been to damn long since the last time. :wink:

[OICU812]

Thank you Clint, this will prove to be an extremely usefull thread for many that will buy the Razor or the CC85HV, an excellent and proven starting point. Thank you for all you efforts on the matter. :woohoo

[Clintstone]

Looking forward to getting feedback from you guys when the Razors go out..........should be alot of fun. I am ready to get a paint scheme on mine that I usually fly.

[scottycigar]

Hey clint scott from nyc here. I am looking forward to getting my razor asap so i can see if it is as good as i am expecting it to be. I am going to use your settings posted here on my hv85 with a 45-08 and 4350 5s1p packs i hope it works pretty good. I have a question regarding the shims for the head. which ones did you use the soft medium or hard.

[wattybotts]

The Razor is coming with the one piece dampeners and stock shim. It works just fine and that is what all of us are currently running in the Razors.

[Clintstone]

Bobby is correct.

[WillJames]

Here is the HV-85 Setup Video with Clint Akins Link

http://www.helifreak.com/viewtopic.php?p=215827