GY401 with 8103 Radio Setup

[RCHeliJim]

Hello again all,

I have installed my new GY401 in my rappy, and I plugged the remote gain into the AUX 2 of my 770 rx. I am still a beginner, so I am not using any flight modes, D/R, etc. If I leave the gyro gain function in my 8103 as Inhibited, will the gyro just default to 100% sensitivity? It stays in AVSC mode with the remote gain inhibited. DO I just need to enable the gain function and set all modes to 75% or so?

Also, what length from center is common for the ball link on the 9253 servo arm on the Raptor 30?

Thanks for your help, Jim

[rob_jones]

Gyro gain is set using the ATV (end point adjustment) of the channel for the remote gain. In this case AUX2. It would be a good starting point to set it to about 60% in heading hold. If you're not sure if it's right, try to find somebody locally who can check it out for you.

The distance from the ball link to the center of the output arm usually works best around 10-12mm.