DebianDog
12-04-2006, 11:06 AM
Bob shows you the basics everyone should know (http://video.helifreak.com/?subpath=finless/trex450&filename=gyro_setup.wmv)
HeliDan
03-08-2007, 01:34 AM
Thanx for that. I am slowly nearing the need for that!!
buellbeast
08-08-2007, 02:03 PM
I am in Iraq and our bandwidth isn't what it is in the States. So if you could for a quick reference put the settings which are seen on top of the Gyro and also what would be a good start for a DX7 radio. I have a TREX 450 SE blinged out and am having trouble with the heading hold feature. When I make a large power damand the tail will want to go right. I know it should hold but seems to be lagging behind. I am running about 75% on the gain in my radio and it just will not stop the tail.Thanks
Sherpa FE
08-10-2007, 03:32 PM
Where at in Iraq, I am running the exact same set-up here in Kuwait, and I fly into Iraq almost every night. Any of your friends interested in buying a T-Rex 450 HDE with servos, esc, extra blades and spare parts? No Gyro, or Reciever.
If you are using a digital servo use the following.
Delay to Zero
DS to ON
DIR, to whichever way it works
Limit pot set in standard rate mode.
75% sounds about right, and I believe that when you pull an armpit full of collective that it should pull the tail a little bit, not sure that you are going to get that out. Does it hold solid any other time?
PM me maybe I could get you a copy of the Gyro video, on disc, along with Jermo's video using the DX-7 and the 401 Gyro set-up.