Tail set up question (edited again)

[ferincr]

Hi, I finally got my rudder servo gears and now I have to re set the tail.
I remember reading a good article on how to set the tail correctly, but I can't remember where. That's the problem living in a country where every time you need spares you have to order them from the US and wait forever, (too much time to read and browse forums :roll:)
I looked in raptortechnique (I'm pretty sure that that is where I saw it) but couldn't find it.
Basically I got it centered but I remember reading that the servo end point would not adjust how far the servo will go but the speed it would get there (or something like that) and the servo travel should be adjusted via........... :arggg: :arggg: :arggg:
Now, who's up for fill in the blank???
I'm talking about a Raptor 60 and futaba 9chps (just in case)
Thanks in advance,

[ferincr]

Never mind, I found it. It was in raptortechnique (under the gyros section) :mrgreen:

[BarracudaHockey]

We dont generally delete anything but duplicates, you never know when someone else may benefit from a post.

[DebianDog]

Yep great site http://www.raptortechnique.com/ helped me a lot when I first got my Rappy.

[ferincr]

Ok, so I guess I re edit the tittle so people can know what this is about, thanks.