Could someone be kind enough to check my settings

[MarkD]

Asking a favour of you guys with a 14MZ. As this is a completely new beast to me could some one who owns a 14MZ just go through the attached model settings for my Trex 450SE. ie I haven't set/not set anything up that will put the heli out of control the minute I spool up. Most settings are at default - ie Gyro rate untill I hover and get the best

Gyro = CSM SL420e (Rate are reversed - NOR is in fact AVCS with CSM) using left top rear to switch between the two
Normal-idle 1 front top left
hold - right top front

All the collective servos are throwing the correct directions. The bits I'm not to sure on are the groupings (seperate or group) and priorities with conditions ie hold overides all etc and have I missed any vital settings

Untill I get my head around this Tx all the help would be greatfully recieved :D

Thanks

[Finless]

Here is my Trex450. Servo reversing and CCPM may be different but this will allow you to see gyro settings, idle up and hold ssettings, etc.

Bob

[MarkD]

Thanks

I'll browse and compare tonight :noteworthy

[OKerbaul]

Hi Finless,

I have a 12ZHP mode 2 and a model name like your Trex SE 46.mdl cannot be used on my CF card (unless I am doing sthg wrong). As I have no 14MZ within 5000miles and no real motivation to hack the 14MZ file, would you mind renaming it from your 14MZ (sthg like TR450Bob.mdl for instance) and re-post it, so I can use it? Sorry for bothering you.

Thanks!