How di i hook up the BEC

[opsguy49]

This may seem like a dumb question, but how do I connect the bec? I must be missing something here. The ESC has the two wires to the battery, 3 wires to the motor and the 3 wire plug to the rec. So the ESC instuctions say remove the middle wire from the plug and fold back and secure. The BEC has two wires that I assume go to the battery leads and it also has a two wire plug. I only have one open place in my rec. so what gives? Any advise for this newbie will be appeciated. :dontknow

[Finless]

Use channel 5 gyro gain plug and put the 2 wires from the BEC in there. Inside the RX all positive and negative pins are connected by a buss bar so power can be placed on any plug. Since the 401 gyro gain plug only has one wire in it you can use the open pin locations.

Bob

[opsguy49]

Thanks for the reply, I was hoping there was a way to do this, I didn't want to have to buy aaother rx or radio just yet. :noteworthy