enigma
12-15-2006, 07:02 PM
I just got another dx6 tx. When I try to bind it nothing happens. Is there a way to unbind the rx from the other radio or is it dedicated for life? I was under the impression that simply binding to the new tx would also unbind it from the old tx. Could there be a problem with the new tx? When I turn on the rx with the bind plug in, it does not light up. I have two rx and they both do the same thing, I have even made a new bind plug to rule out any faulty connections. Any ideas?
Jermo
12-15-2006, 07:24 PM
I recall reading about minor binding issues with the DX6, Check www.horizonhobbies.com support there's some posts somewhere..if you can't find it holler and I'll find it.
The Rx can be bound and rebound to other TX at will, just make sure you're following the exact proceedure (I don't own a DX6 but I've read ALOT about it and teh DX7).
Excerpt from dx6 page
1) Put the bind plug into the BAT port of the receiver
2) Power up the receiver
3) Press and hold the bind button on the back of the Tx while turning on the transmitter
Are you following that procedure?