AdrianM
12-22-2006, 11:58 AM
Its seems like there is a shortage of pinons for these new helicopters. In talking to a few owners of shops there seems to be a need for quality 1.0 Module pinions for 5mm and 6mm shaft motors.
I run a company that imports R/C cars and I have contacts to get high quality hardened steel gears made to the proper specs. These gears will run quiet, true and may out last your heli.
I want to get an idea about the demand for specific sizes so if you could respond to the poll it would be much appreciated.
I dont have enough poll option to poll the full range of 6mm pinions too so just post if you need 6mm pinions.
These will be also be available in the correct sizes and pitch for the Trex 450, 600 and Logo 10/14. Check the threads for these helis and vote in the polls for their pinions.
_________________
Align Trex 450 SE, Spectrum DX7, Hitec HS-65MG servos, Futaba 401 Gyro w/ Airtronics 94761 Digital Tail Servo, Castle Creations Phoenix 35, Medusa 28-40-2500 (15T), Thunder Power 2100 3s
I run a company that imports R/C cars and I have contacts to get high quality hardened steel gears made to the proper specs. These gears will run quiet, true and may out last your heli.
I want to get an idea about the demand for specific sizes so if you could respond to the poll it would be much appreciated.
I dont have enough poll option to poll the full range of 6mm pinions too so just post if you need 6mm pinions.
These will be also be available in the correct sizes and pitch for the Trex 450, 600 and Logo 10/14. Check the threads for these helis and vote in the polls for their pinions.
_________________
Align Trex 450 SE, Spectrum DX7, Hitec HS-65MG servos, Futaba 401 Gyro w/ Airtronics 94761 Digital Tail Servo, Castle Creations Phoenix 35, Medusa 28-40-2500 (15T), Thunder Power 2100 3s