help! micron fp v2

[trex600cf]

i have bout an micron v2 35mhz.And have an futaba 9c tx i'like to use to fly this thing.The elevator and aileron works ok,but the main motor dosen't spinn at all,and the tail motor dosen't spinn when moving the rudder stick.Please help me get this heli in the air.I'm thinking it is the Futaba tx setup i'm not getting right.Anyone ho can help me setting up the tX for the micron?

[Coolice]

Hey,

Just an idea but have you tried reversing the throttle channel in the Tx? Most electric models need to see a low throttle condition before allowing the motors to start.

A quick check is to place the throttle stick in the full power position and see if the speed controllers then arm.

One word of caution, be carefull still as although it's a small model it will still hurt if it hits you :?
.

[trex600cf]

Yes i have tried reversing the throttle channel in the Tx.And i have tried to arm the esc on full trottle.And my trottle curves start at 0.The 3 in 1 gyro/esc http://images.google.no/imgres?imgurl=http://www.ltair.com/images/products/3in1board/3in1_2.jpg&imgrefurl=http://www.ltair.com/products/3in1Mixerboard/3in1Mixerboard.htm&h=338&w=450&sz=43&hl=no&start=3&tbnid=ZCUhvcmlIBivJM:&tbnh=95&tbnw=127&prev=/images%3Fq%3Dba-mb-he02%2B%26svnum%3D10%26hl%3Dno%26lr%3D%26sa%3DG
have the right conections to the rx,so i dont understand this :arggg:

[trex600cf]

I forgot to mention this blue light on the esc not flash,it's ligtning all the time when the power is on.what that means?

[Coolice]

Hey,

Hmmm, weird problem this one. I just clicked on the instructions link from the above one you posted and they pretty much advised what I dod about checking channel reverse and position etc.

One other thing you could try is increasing the travel points for the throttle top and bottom slightly, in the past I have come across Castle Creation controllers which need an extra 2~4% on the travel limit to arm. Another quick thing to try.
From the spec the blue LED should blink to signal it's armed and ready, in this case it's not arming and so the above trick maybe work if it's not being driven to low throttle enough.
.

[trex600cf]

Hmmm.thangs for the tip, i'l try that.

[trex600cf]

Hi again coolice it's work now thanks to you i have to set the endpoint to 140% to get it work. Thanks,it was a nice cristmas present :lol:

[Coolice]

Hey,

Ah brilliant, your very welcome. Glad it's all now working for you.

The model certainly looks to be a nice present to buzz around the living room, just mind the tree or you'll get into trouble :twisted: :wink:

Happy Christmas :cheers:
.

[trex600cf]

the micron v2 is flaying very nice.And i'm storing it very nice to :)

[Coolice]

Hehehe, it's got it's own little suitcase to :D

Good idea and similar setup to what the hardcore PiccoZ fliers have, a protective case to store it in.
.