Where can i get the following parts???

[jlbpropilot]

Can someone please tell me where i can get some of the left/right threaded turnbuckles for contol rods on a fury extreme? Also, is there anyone that makes JR servo wheels big enough for this application? Futaba has the nice big ones, but I have been unable to find similar ones for JR servos. Thanks!

[bighands3d]

You can try Ray's Heli Resource for your turn buckles

Although they don't recomend them for hard 3D. As far as the big wheels I just use the HD JR straight arms have never had any problems. I don't think they make any that are plastic I preffer the plastic ones over the metal, helps keep from breaking gear sets.

[jlbpropilot]

Thanks, I am just having a bit of a time getting my arms to line up perfectly 90 degrees without using any subtrim.

[bighands3d]

you need try shannon's Fury set up videos in the video section. if your having trouble setting up your machine.

You'll have to use some sub trim to get them at 90 degrees. I just set one up last night. It was an Xtreme. I had to use some but not much.

[DavidH]

You can use the Airtronics large heavy duty servo wheels on the JR Servos.
Airtronics and JR use the same spline count on there servos.

These are the ones you want
http://www.ronlund.com/Merchant2/merchant.mv?Screen=PROD&Store_Code=heli&Product_Code=AIR98324


I suggest these rods for your Extreme, if you do not have them on it already.

http://www.ronlund.com/Merchant2/merchant.mv?Screen=PROD&Store_Code=heli&Product_Code=MA120-96

David

[jlbpropilot]

Thanks David, you are the MAN!