Blade CP Pro wants to spin clockwise

[cabate]

I just got a CP Pro and have flown one before. I was trimming the heli for the first time in my basement and ran into a problem it lightly tapped a pole after a little ground effect was from the mains. I replaced the main rotors but notice that now the heli wants to spin in a clockwise movement. I have adjusted the pot settings and am using full left trip for the tail rotor and still need to give it almost full left in order to keep the tail from spinning. I have looked over all my connections and changed the tail rotor just to make sure. Does anyone know what I might have done to cause this. Any help would be greatly appreciated.

Thank you,

[raspykart]

Make sure the tail rotor blade is secured into the holes of the black gear, make sure the rubber hose is holding the black gear in place to connect well with the motor, adjust the gain and/or trim on the 4n1. Otherwise maybe a bad motor or a battery not fully charged. I had to get my tail motor replaced not long after the first hover.

[MikeR.]

Double check the bushing on the tail motor. It's underneath the pinion. A couple of small bumps and the bushing pops out of the motor - has happened to me many times. It that's not the case, on your trim pot, turn it lock to lock then return it to original position and plug it in. That's always worked for me.