Tap your experience for GY-611 in Razor

[jrohland]

I have been [re]building my Razor 600e according to the build instructions. I noticed the installation and setup of the Futaba GY-611 Gyro is devoid of much detail.

Which wheel/horn do you use? Which hole do you put the ball in? I notice the linkage scrapes the frame unless the ball is installed from the back side of the wheel. Is that how you did it? How did you setup the Gyro control amp? Right now I am at factory default. Finally, did you need to reverse the rudder channel in the control amp and/or radio?

Thanks for giving a starting point,
jrohland

[DavidH]

Put on a servo wheel and position the ball. So it will allow you full throw each direction. You would need the travel adjustment on the gyro screen at least above 100% each direction.
Rudder direction is controlled by the transmitter.
The reverse in the gyro amp adjusts the direction the gyro operates.
For example.
If you twist the heli with the nose going to the left. The tail should get a right direction command. If it is getting a left direction command the gyro would need reversed.


Page 85 of the manual. Do you have the tail servo mounted like the picture. If you have the servo with the mounting lugs of the servo on top the frame. The servo is sitting too high. It needs to be mounted so that the frame is on top of the lugs.
David

[misskimo]

hey , I still use JK setting I copied off his website some 3 years ago , I use it for a base line , it will get you close



Fury Extreme 90 GY601 Settings:

I only use the gyro in AVCS Mode (heading Hold)



Parameter
Value
GDir - Gyro Reverse ? on the razor it might be different
REV
G:1 - Gyro Gain Adjustment 100%
G:2 - Gyro Gain Adjustment Not used
ACGA - Rudder Control Gain 120%
ACGB - Rudder Control Gain 120%
NCGA - Rudder Control Gain Not used
NCGB - Rudder Control Gain Not used
D1IA - Control Delay (Delay when rudder stick operated) 0%
D1IB - Control Delay (Delay when rudder stick operated) 0%
D1DA - Control Delay (Delay when rudder stick released) 0%
D1DA - Control Delay (Delay when rudder stick released) 0%
Trk - Gain Tracking (Adjusts left and right braking tracking) 0%
Mode - Operation Mode Setting CMT (I use HH all the time)
Fmod - Flight Mode F3C
AVS - AVCS Sense 100%
LmtA - Linkage Limit Setting 102% different on the razor , adjust so slider dont hit
LmtB - Linkage Limit Setting 145% same as above adjust for Razor
Gyro Gain Normal Mode - Set via Code 44 on JR10X Radio 35% (74% JR10X)
Gyro Gain Idle Up 1 Mode - Set via Code 44 on JR10X Radio 35% (74% JR10X)
Gyro Gain Idle Up 2 Mode - Set via Code 44 on JR10X Radio 35% (74% JR10X)