HeliHolic
12-29-2006, 06:21 PM
I did a search on the forum and see lots of posts on glitching, anyone have a idea why? Mine is not bad, maybe one or two in 3 pack run time. But I really like the little bird, IMHO one of the best birds to learn with. After a nose in from 70ft free fall when my battery came unplugged :badair: repairs were less than $20.00
Slick
12-29-2006, 09:18 PM
I did a search on the forum and see lots of posts on glitching, anyone have a idea why? Mine is not bad, maybe one or two in 3 pack run time. But I really like the little bird, IMHO one of the best birds to learn with. After a nose in from 70ft free fall when my battery came unplugged :badair: repairs were less than $20.00
I am not sure why but I love the BCPP. With that said I have to say at least 90% of all the crashes I have had was because of glitching. On my heli it is bad. I recently bought a TRex 450 SE with a DX7. The new mini Rx recently came out and I have one for my BCPP. I am in the process of setting my BCPP up now. I can say while I am setting it up, I believe my glitching problems will be over. Usually after I turn it on, the servo's are making all kinds of noise and now they are not almost at all. I can't wait to see how this thing fly's whith out glitching.
I wish I knew why because I would have tried to either replace the offending part or tried to modify it to get rid of the glitching.
Some suggestions I have read are to: 1) Remove both Crystals, clean them, and reinsert them and make sure they are fully inserted. 2) Check the antenna to make sure it is not damaged. 3) EMC, add a Ferrite to try and suppress the electro magnetic noise. This is more if you have an ESC I believe. 4) Rewire it so the wires are away from the motor and the ESC if you have one, and make srue your ESC is not near the Rx or the antenna.
These were most of the things I have read about glitching.
Those are the most common things to look for.
magicheli
01-02-2007, 05:40 AM
Hi HeliHolic, first sory for my funny english *SMILE*.
I Fly since 9 Weeks with the Blade, but i solved all the problems of thet little beast, ilove that little machine now really. Can remove Hands 4-5 seconds in hover.
I had the same problems first Moth.
My Sugestions: 1. What Slick said is right. 2. If you are using the original Radio you will have several problems, best you chage it, or chap version, spray a little electronic tuning spray in the 4 little holes on the POTENTIOMETERS inside the Eflite Radio, it solves the moste of your gliching problems, after it, myne was runing 100% smooth. The original POTENTIOMETERS are very cheap quality. Also the eflite reciever is not really a god one, its very recomended to replace it too, but if you start doing expensive stuff like this, then better change your tail to direct drive too, permanent fix is a brushless tail, a Gyro, remove 3 in one, but this is another story :wink: . 3. be shure the antenna has min. 1 inch distance to evry electrical wiring. Important was also to set my amtenna not arround you landing gear, better is strech the antenna arround your heli, down to the landing gear and back to the tail, and back on the other side, if you can protect it with little antenna tubes. Be shure have no Contact woth any metal or cabon parts directley. With this little changes you will have no problems with your glitchings anymore.
Best regards Mario :D
BCP PRO
Alu Heck
Plastic blades
Alu Hiller
Futaba FF7
Brushless Miin Park 370 KV41
Brushless Tail Feigao
GWS 3040 Prop
Reciever Schulze
Controller Phenix 10 / Eflite 20
1320 mAh Thunder-Power