611 not holding onSpectra G

[skiboy]

Yes I was wondering on how to get the tail on my spectra to hold , during hover the tail will keep swinging to the right and I have to keep some right input to maintain a straight heading . Any help or suggesstions please...

Thnks..,.,.

[mudbogger2]

What are yor setings in the gyro? How far out is the ball on the servo arm?
Is the engine running properly? Not lean or vibrating.

[skiboy]

No the engine has only 4 tanks of assless break-in oil so far, and the servo arm is out on the fourth hole whichs makes the rod level and at a 90 degree.. The setting on the gyro is set to AVC 100% and on my receiver the gyro sensor is set to 35 %..
Today I took off the strap that I had on the gyro and it seemed to do better but there is still alittle very little of movement, it just doesnot hold like the Logitech 6100T like I have on my Raptor 50, but still I am not sure if I am doing something right..

[mudbogger2]

what are the limits set at on the gyro?
The setting on the gyro is set to AVC 100% and on my receiver the gyro sensor is set to 35 %..
So you are at 35%gain?

Just so you know I am not a gasser guy but I do know the gyro very well. If that motor is new and being run ritch it may have some vibrations in it. this will cause some funny stuff with the gyro.

[skiboy]

I am only about three months into the world of helis so maybe I am not understanding what you mean? I have a raptor 30,50,90 and a trex se and all have the 401 with no problem and the 50 has the Logitech 6100t and no prob but the 611 I don't understand...

[mudbogger2]

In your gyro menus screen, scroll through the Function menu with the function buttons. See what the numbers are for Limit-A and Limit-B. Also what is the reading on the gyro when it initalizes?

You also need to look at the . in the voltage number (ex 5.4V) If it is a large black square at startup your neutral points are not centered(trim is applied) if it is a normal decimal point then do not worry about that.

[skiboy]

at start up the screen displays the voltage and the 38a which is 38%avcs on the gyro gain sensor I think and I know that there is not the black square there because I helped a friend setup up his on a Vibe and found out about the solid black square...