racerman27410
01-02-2007, 10:32 PM
Hi,
First post here but have been lurking and reading alot :-)
Anyway i bought a DX7 to use with my MX400 and thought it might be fun to bind it to the stock Rx in my CX2.... no problems binding and reversing a couple of the servo switches for proper control movement but when i tried to fly the CX2 it had real bad tail wag.
i played with the 4in1 gain on both directions but couldnt adjust it out.
went back to the stock Tx and the tail is solid again.
was i missing somthing in the setup of the DX7 Tx or was it just overpowering the CX2 receiver? it did seem that the control response was much faster using the DX7 but that wag was bothering me.
thanks in advance,
Frank
First post here but have been lurking and reading alot :-)
Anyway i bought a DX7 to use with my MX400 and thought it might be fun to bind it to the stock Rx in my CX2.... no problems binding and reversing a couple of the servo switches for proper control movement but when i tried to fly the CX2 it had real bad tail wag.
i played with the 4in1 gain on both directions but couldnt adjust it out.
went back to the stock Tx and the tail is solid again.
was i missing somthing in the setup of the DX7 Tx or was it just overpowering the CX2 receiver? it did seem that the control response was much faster using the DX7 but that wag was bothering me.
thanks in advance,
Frank