im angry with my mx400

[bigsix]

had a wreck, went and bought some parts to fix it all back up...
picked up a billet center hub and some billet mixing arms, along with new blades and whatnot...long story short, the rest of the seesaw and flybar parts dont fit around them..so i go back to the lhs and compare billets pieces to plastics...p.n. hmxe8810 plastic stabilizer control set is significantly small in "diameter" than its billet counter part...billet p.n.hmxe8806 is bigger than its plastic equiv...bummer....at least imma have a pretty head when i am done.its just bogus that the parts them selves arent necessarily interchangeable..have to buy it all i guess...told the wife i'll need the blade grips and ccpm kit too, to make it all work right..

[steve28]

you should be able to make it work using the four point swash and leave your upper frames the way they are I think . I have seen this done , all metal head with the single servo for pitch . But you will have a better machine if you go with the 120 degree swashplate and the upgraded upper side frames with he new servo locations .