Helirono
01-09-2007, 12:42 PM
Hello,
I've just set up 2 X GY401 on the camera axis on my Observer EB, has it is on the turbine observer. The difference that I want to place it directly on its action support on heading lock mode, for a better precision.
The problem is that I couldn't increase the gain control to switch the HL mode without impressive vibrations of "pumping" (from 10%, lower to have a gyro control).
I'm not very good at English and I hope you understand what I try to explain... The problem still with a 100% delay and minimum limit on the gyro.
Have you tested with a 9254 servo which is so speeder than the 9252 ?
Or, have you got a solution to decrease the sensitive of the GY401 but keep gyro functional heading hold function ?
Thank you,
Renaud SILVESTRI
I've just set up 2 X GY401 on the camera axis on my Observer EB, has it is on the turbine observer. The difference that I want to place it directly on its action support on heading lock mode, for a better precision.
The problem is that I couldn't increase the gain control to switch the HL mode without impressive vibrations of "pumping" (from 10%, lower to have a gyro control).
I'm not very good at English and I hope you understand what I try to explain... The problem still with a 100% delay and minimum limit on the gyro.
Have you tested with a 9254 servo which is so speeder than the 9252 ?
Or, have you got a solution to decrease the sensitive of the GY401 but keep gyro functional heading hold function ?
Thank you,
Renaud SILVESTRI