Anyone used a HH gyro w/ 4n1 in BCP

[drphoto]

I hacked the 4n1 on my BCP to run a DX7, which is a huge improvement. I've got a GY401 sitting around waiting to go into my Rex project, and thought I'd try it on the Blade. However I read a post somewhere that you can't turn of revo on the 4n1 like you can w/ the 3n1 or the Pro. Is this true? Anyone had any luck running an HH gyro on the original Blade?

I'd hate to spend the money on the 3n1 since the hack was so simple.

thanks

[stikflyer]

With the 4 in 1 you will need to remove the front of the case and then remove the mixing board to gain access to channel 3 & 4 connectors. You will be left with just the RX so you will also need two ESC's.
I done it with my blade and it works fine.