binding cp pr 2 to dx7 small prob

[jonboy688]

got everything binded up to my dx7 but i am having a small prob, the red light stays lite on the esc and will not send power to the esc... i rebound it to the factory tx and the light lite up green and all worked fine, so i retryed it with my dx7 and i would have to go into end points and had to make low throttle on the throttle to 110% then soon as i took it off throttle hold it would spin up a big amount... can anyone help me out with what i am doing wrong? only reason i got this heli was so i could put the heuy kit on it, got it all installed and was checking to make sure it was all setup right when i ran into this problem last night

[Bluerocktj]

Set your throttle trim all the way to it's minimum setting. Your ESC should initialize after that. Hope that helps.

[jonboy688]

then leave it in the postion of the trim all the way down?

[Bluerocktj]

then leave it in the postion of the trim all the way down?

Yes, just like on the stock TX.