My second video "Learning inverted flight on mx400 pro&

[fedex]

sorry about the quality, it gets better as it goes on. My dad must have forgotten how to work the zoom on the first half of the video. Watch closely and you will see a glitch first hand, doesn't happen that much, I may have been pointing my tx at it :)

http://www.youtube.com/watch?v=SPlQppfPkqI

Optic 6 tx
Electron 6 rx
Futaba GY401
430L 3550kv 12T pinion
Align 315mm pro woodies
HS65's & 81
Align blade grips and tail tube

[racerman27410]

Regarding your glitch... i had a similar thing happen and after spooling up the heli with the main blades removed i found it to be the one way bearing going bad . When it slipped it was acting just like yours.

Frank



--------------------------------------------------------------------------------------------------------------------------------------------------------------------------

sorry about the quality, it gets better as it goes on. My dad must have forgotten how to work the zoom on the first half of the video. Watch closely and you will see a glitch first hand, doesn't happen that much, I may have been pointing my tx at it :)

http://www.youtube.com/watch?v=SPlQppfPkqI

Optic 6 tx
Electron 6 rx
Futaba GY401
430L 3550kv 12T pinion
Align 315mm pro woodies
HS65's & 81
Align blade grips and tail tube

[fedex]

tx for the info. I'll look at closely when I disassemble for the ccpm frame.


Bo

[racerman27410]

mine would only slip under load... IE spinning it up with the main blades off...It was very glitch-like

Frank

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------
tx for the info. I'll look at closely when I disassemble for the ccpm frame.


Bo

[fedex]

mine would only slip under load... IE spinning it up with the main blades off...It was very glitch-like

Frank

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------
tx for the info. I'll look at closely when I disassemble for the ccpm frame.


Bo

I'm sure I should change the stock ones out with better cnc ones, but thats another 100$ down the road, I want to do the tail drive gear as well. I really don't trust the plastic at the rpm I'm running.

Just finished the carbon ccpm upgrade tonight. Can't wait to try it out. I had to dremel out all the servo holes and re-drill the holes for my hs65's. Ntm grind part of the antirotation arm. Kind of a pain the ass mod.. But its looking good. I have to arrange the electronics first, but I have everything working on my radio, servo linkage is set, trimmed, and level.

[kenpsych]

That bird flies nice!

[whattheheli]

fedex did you ever do any 3d with this heli before you changed to ccpm ? i am seeing that giving neg pitch may be an issue with the canopy on mine !