vinrx7
09-28-2004, 11:44 PM
Well, i crashed it today. Not too bad, just the basics. Blades, output shaft gear. thats it! I think i will replace the spindle while im at it though. i always replace it in a crash even if i dont see any damage. I went ahead and took off the boom and the tail drive shaft cause i noticed the pinion gear from the shaft was rubbing on the output gear sleeve. i cleaned, re pressed the input gear with a dab of glue to hold it in place and then re assembled. One thing i noticed is that the center of my boom has a bearing and not a bushing. I thought that was weird cause everyone had been complaining about wear on the shaft from the bushing. STUPID TREE! jumped out in front of the shogun.