malc1
02-20-2007, 11:26 PM
Hi
I`m using a 5.46 volt regulated supply from a 4000mAh Li-Po to run the setup with possibly 8 servos( 6 digital) in my scale heli.
Can any one tell me if this voltage will be ok to supply the G490T gyro and 8700 tail servo?
The servo is rated at 4.8v so do I need to drop the supply down to this with one of the commercially available step down devices?
Not sure if 4.8v is required for the gyro though. :dontknow
I`m using a 5.46 volt regulated supply from a 4000mAh Li-Po to run the setup with possibly 8 servos( 6 digital) in my scale heli.
Can any one tell me if this voltage will be ok to supply the G490T gyro and 8700 tail servo?
The servo is rated at 4.8v so do I need to drop the supply down to this with one of the commercially available step down devices?
Not sure if 4.8v is required for the gyro though. :dontknow