Carbon Battery Support For Logo 10 "CF"

[qb7ops]

Hi all,

I have a Logo 10 Carbon Fiber frame set and would like to pick up a pair of battery plate supports for it. I have seen the supports on many L10's here. Could someone please confirm that the Mikado Part #M2007 will actually fit on the L10 CF? http://www.fxaeromodels.com/product_info.php?cPath=49_45_210&products_id=3081&osCsid=4cfd2407d547367fc7f46662100102e4.

I want to make sure the supports will "actually" fit because the last time I purchased a part that said it was for a Logo 10, it turned out not to fit the Logo 10 CF, but did not state that.

Thanks in advance!

[MicroMan]

I know it'll fit on the plastic frame, you may want tp give fxaeromodels a call and confirm it'll fit on your CF Logo 10.

[qb7ops]

I did send FX and email, but I am sure someone on helifreak will know. (At least I hope so) :D

[Chachin]

Hello,

It probably won't be a direct fit. You will have to drill a couple of attachment holes at the low and fwd end of the CF frame for it to align properly and support the underside of the long battery plate.

Haven't tried it myself though. Here's how an E-Zone member did his longer version batt. cradle in his Carbon Logo10:

http://www.rcgroups.com/forums/showpost.php?p=5178779&postcount=10

Chachin..

[BobbySmith]

I went to install one on my CF 10 and it was going to take some work so instead i added plateoff the botom of the motor mount i extended it about 2 inches out and holds my 6s1p 3700 evo flawless


Bobby

[ozace]

Thanks for the link Chachin, i missed this post

[BobbySmith]

Nice work Ozace!

Bobby

[qb7ops]

It looks like the one Ozace attached is the M4000 and not the M4007. The M4000 looks longer in the picture and might be easier to adapt than the shorter looking M4007. I hope I am correct on this. Will give it ago just the same.

M4007 http://www.fxaeromodels.com/product_info.php?products_id=3081&osCsid=db4e3ff07de9da384850492ada1bdc76

M4000 http://www.fxaeromodels.com/product_info.php?products_id=2582&osCsid=db4e3ff07de9da384850492ada1bdc76

[ozace]

The reason i used the longer one, is the logo i have it intstalled on has the 550 stretch kit and i needed the packs as far forward as possible to balance. The smaller mount attaches the same way (i have it on my other logo10)

[qb7ops]

So either one....good stuff Ozace. I will go with the shorter ones until I have the need to stretch. Thanks againf for you input.