Razor - mounting motor and front pulley problem

[buster1]

If any of you guys have mounted the Hacker A50-14S, I am having a problem,
The motor needs to be mounted to the motor plate with 4 4mm bolts and when I mounted the front pulley on the motor shaft, flush with the motor plate - when turning the motor, one of the set screws which holds the pulley in place, could not get past one of the 4mm bolts (basically, the motor can't fully turn because set screw is hitting the head of bolt) - set screws are as far as they can go. I am a little baffled - I must be doing something wrong, but have not figured out my problem.

Any thoughts,
Thanks,
Jeff

[buster1]

Also, it seems you need a very long allen driver to screw the motor mounting bolts down - otherwise, I can see how to secure the motor plate.

[lawrenmd]

Had the same issue with the set screw. Just take a little material off of the hex side, it still leaves plenty of meat for the wrench. As for the plate bolts I just use the standard ball end allen wrenches which work fine.

[buster1]

cool - before reading your response - I decided to give that a try and worked out fine - took a dremel and removed some excess material. Regarding wrenches - I had to pull out the ball end allen's as you suggested. Thanks a lot!!,
Jeff