vrwired
03-06-2007, 01:00 PM
Hey.. this sight rocks..
I am in the middle of building a Hornet X3d (first heli).. All Alum upgrades from MScomposit.. Microheli tails servo mount, horizontal fin/mount, bell crank and Microheli tail gear case. I HATE GLUE!
Note- Microheli tail slider horn would not fit on the blade grip "pins"... the holes are to small.. hmm.. ended up using MS stock slider/horn with the alum bell crank from Microheli.
Note- Microheli fins are going to break.. I know it.. hmm.. Maybe I will fashion one out of an old Visa card.. heh... it will look like my heli is sponsored by Visa! .. heh... or cut some out of CF....
hs-50 and 55
ms-116 esc
twister 300/20
gy401
commonsense lipo 1250 mah 10c
The Microheli tail gear case was very hard to put together.. so many tolerances to deal with.. :arggg:
A tip .. if you need a new spacer (I sanded mine to short) pull apart a Bic pen and use the end of the tube that holds the ink! It fits perfect! :mrgreen: Just roll an xacto on it for a bit and it will cut off nice and clean... then sand to size...I am not sure if that has been said by anyone else.. But if not... I am glad I could contribute. This forum has really been helping me so much.. Thanxs...
I just got my DX7 and love it even though I have not even used it.. I can't wait to spin my blades up...
been practicing on G3 for a year now...
Later
I am in the middle of building a Hornet X3d (first heli).. All Alum upgrades from MScomposit.. Microheli tails servo mount, horizontal fin/mount, bell crank and Microheli tail gear case. I HATE GLUE!
Note- Microheli tail slider horn would not fit on the blade grip "pins"... the holes are to small.. hmm.. ended up using MS stock slider/horn with the alum bell crank from Microheli.
Note- Microheli fins are going to break.. I know it.. hmm.. Maybe I will fashion one out of an old Visa card.. heh... it will look like my heli is sponsored by Visa! .. heh... or cut some out of CF....
hs-50 and 55
ms-116 esc
twister 300/20
gy401
commonsense lipo 1250 mah 10c
The Microheli tail gear case was very hard to put together.. so many tolerances to deal with.. :arggg:
A tip .. if you need a new spacer (I sanded mine to short) pull apart a Bic pen and use the end of the tube that holds the ink! It fits perfect! :mrgreen: Just roll an xacto on it for a bit and it will cut off nice and clean... then sand to size...I am not sure if that has been said by anyone else.. But if not... I am glad I could contribute. This forum has really been helping me so much.. Thanxs...
I just got my DX7 and love it even though I have not even used it.. I can't wait to spin my blades up...
been practicing on G3 for a year now...
Later