View Full Version : dx7 setuo for g90 gyro on blade cp pro?
lhortizuela
03-07-2007, 02:49 PM
will the g90 work with the dx7? can i remotely adjust the gain on the dx7? thanks.
larry
carlo_the_wonder_frog
03-07-2007, 08:53 PM
yes and yes.
lhortizuela
03-10-2007, 12:15 AM
i finally got the dx7 to run with the bccp and its real smooth. i dont know about the g90 though. its not holding as well as i want it to. can i use rudder trim to straighten it out or do i keep the trim center and only use remote gain?
larry
carlo_the_wonder_frog
03-10-2007, 07:09 PM
You should use subtrim on your rudder if it constantly creeps. Make sure the temperature has stabilized on the gyro before you plug in the battery. Might take 10 minutes of letting the heli sit outside first. set the gyro remote gain connector on the gear channel and use the gear switch to switch between rate and Heading Hold modes, then all you have to do is adjust the Gear channel on the [travel adjust] screen to adjust the gyro gain. Your gyro may not be in HH mode and that may be why it is moving around so much.
Hope that helps you.
lhortizuela
03-10-2007, 10:11 PM
thanks, my gyro remote gain is connected to the gear channel and i selected gyro for the gear channel and using a value of 85%. its holding pretty well now. it similar to how i set up my trex.
larry