View Full Version : Airtronics servo horn/wheel with 25mm hole spacing
I'm using airtronics servos and the horns have holes at 13mm each side of center but need 12.5. I can't find airtronics or JR servo wheels that aren't drilled out and suspect they're at 13mm each side too. I can make that work of course, but wondered if any of you have found such a thing as undrilled Airtronics or JR servo wheels.
Thanks,
Tom
TMoore
03-08-2007, 08:01 PM
Sure.
OK, clever and thanks!
Tom
TMoore
03-08-2007, 08:56 PM
Tom,
I have the large disks in a drilled and undrilled forms.
Terry
where on earth did you find them or did you make them? I can only find the drilled ones---they are all over the place--but blank ones seem to be scarce beasts. Let me know and thanks. Tom
AdrianM
03-22-2007, 08:49 PM
They are Airtronics P/N 98324. They have some holes in them but they have open spaces for drilling holes too.