breezer1
05-25-2011, 08:18 PM
Burned up a digital tail servo by leaving "Analog" set.
wasted a speed controller by not unplugging it and back powering with a seperate LIFE pack for programming
Took a while to get to the firmware update stage thinking the unit was factory new just in from backorder
Finally got the "Transmitter Type" selection option.
Tail would not hold
Tail would not hold
Aha! tail gyro reversed!
Tail still would not hold!
Tail servo mounting loops to boom not TIGHT TIGHT TIGHT!
I was ready to throw this thing in the trash or put it on EBAY for .99 cents and get a BeastX
WOW WOW WOW WOW WOW!!! when it is finally right, THERE IS NO DOUBT!
What a locked in rock solid undeniably wonderful piece of electronic wizardry we have here!!
Curtis, I apologize for every epithet and mumble under my breath!
I love this thing! Could never have gotten through it though without this forum and everyone's help!
Thank you all very much!
Breezer1
wasted a speed controller by not unplugging it and back powering with a seperate LIFE pack for programming
Took a while to get to the firmware update stage thinking the unit was factory new just in from backorder
Finally got the "Transmitter Type" selection option.
Tail would not hold
Tail would not hold
Aha! tail gyro reversed!
Tail still would not hold!
Tail servo mounting loops to boom not TIGHT TIGHT TIGHT!
I was ready to throw this thing in the trash or put it on EBAY for .99 cents and get a BeastX
WOW WOW WOW WOW WOW!!! when it is finally right, THERE IS NO DOUBT!
What a locked in rock solid undeniably wonderful piece of electronic wizardry we have here!!
Curtis, I apologize for every epithet and mumble under my breath!
I love this thing! Could never have gotten through it though without this forum and everyone's help!
Thank you all very much!
Breezer1