Struggling to set throttle servo end points

[thefrog]

Hi all,

I've been following the wizards to set up the Sk720 with no hassles except for one step - setting throttle servo end points. My Tx 0% position (closed) shows as '0' on the GUI but 100% (open) on my Tx is showing 80 % on the GUI. Setting my Tx to 150% gives me 100% on the GUI but the throttle is physically not open 100%. What is causing this weird behaviour? Can I reset the entire unit and start from scratch?

Thanks!

[georgi UK]

=] so it loaded then??! reset the Tx back to default trav's re-run the initial config. wizz, the steps you are interested in here will be throttle stick centre & stick scaling in the wizz.

its not needed to touch Tx travels.

georgi UK

[thefrog]

Software is 3.02 and firmware is 3.00. That's right isn't it?

I'll run through the setups again. thanks for the help. Other than this, I've found this really staright forward. Excellent product so far.

[georgi UK]

=] you should be 3.02 for both, update the firmware to the unit in the utility tab. move the GUI panel if you have to, the update screen was hidden behind the GUI screen on mine earlier when I did this!!

georgi UK