Where to get YS61-st2 throttle ext arm to work in raptor 60

[ddierking]

HELP, where can I get a throttle extension arm for my YS61-st2? I just put the engine in my Raptor60 to replace a TT70 and the throttle arm is way too short.

Thanks,

[ddierking]

Guys, I just got creative and made my own, but I would still like to know where I can get one if needed.

Thanks,

[DavidH]

Piece of aluminum or brass tubing. Long 3mm bolt is all you need. Cut the tubing to the length you want the arm extended out from the carb barrel. Get a 3mm bolt to match that length. Put the 3 mm bolt thru the plastic arm, slide the tubing on the bolt. Thread into carb barrel and tighten bolt. That is how I did it on the YS's when I used them.

David

[WayneBrown]

I used a 5mm hex spacer cut to length, then drilled larger than 3mm to allow bolt to pass through it. I also learned this gem from Mr. Harkey..