View Full Version : Drive System tab settings?
schriss
06-30-2011, 10:28 AM
I intend to set Governor to Off. What are the other fields for and do I need to use them with Gov Off? For example those 3 RPM fields, do I use them with Gov Off? I am used to manage my curves in Tx.
heathy
06-30-2011, 10:30 AM
Nope, leave them all off:thumbup: Only needed if using gov.
schriss
06-30-2011, 01:11 PM
Thanks! That means, that ideally when Gov Off, those RPM fields and Low/High Ramp should be all disabled in the software, yes?
What about Set Max/Idle Throttle? How do I o that. Is it to move throttle stick to lowest and then press Set Idle? And do the same for stick all the way up and press Set Max? I don't thnk I had to do similar thing before, before i hooked up SK720...
georgi UK
06-30-2011, 02:21 PM
=] yes, those fields are used for gov RPM's so ignore them. setting the low throttle is the SK fail-safe setting if signal is lost. max is full stick. this should be done when in idle-up Tx setting and with hold disengaged.
georgi UK
fquails
06-30-2011, 02:23 PM
What about Set Max/Idle Throttle? How do I o that. Is it to move throttle stick to lowest and then press Set Idle? And do the same for stick all the way up and press Set Max? I don't thnk I had to do similar thing before, before i hooked up SK720...
Yes. While you're at it, might as well set your Failsafe (go to Utility>Set Failsafe)
Here's a thread about how to set Failsafe:
http://helifreak.com/showthread.php?t=310509&highlight=failsafe