blade cp no motor power after crash - PLEASE HELP

[glowplugconvert]

As the subject says, my receiver will blink red and green without transmitter being turned on but as soon as the transmitter turns on, receiver light goes solid red with no motor power - all other servos are working fine...

This occurred after a particularly exciting crash btw - did I screw it up???

Thanks in advance!

[ch47dfe]

check your idle up switch, if its on-turn it off.

Also, is the throttle/collective stick and the trim all the way down?

Also, check the motor connector on the 3 n 1, is it pushed in all the way?

turn the TX on first, trottle/collective and trim all the way down, then plug in the batt on the heli. :D

[glowplugconvert]

THANKS! This site ROCKS!!! The trim got moved ever so slightly...

[ch47dfe]

No problem, I only know this because I did the same thing when I bought my CP pro.

Your username is glowplugconvert? Is this because your no longer flying gas helicopters? I'm only asking because I'm thinking of buying a 30-50 size gas heli. almost bought a T-rex 450 but i was thinking, if I were to spend over a grand on a heli, I want a grand worth of heli.