PDA

View Full Version : Reflex XTR and JR Radio

harry29
03-26-2007, 03:21 AM
Hi there
can anyone help me I have just purchased my reflex simulator, my problem is that when I open the sim it says, calibrate centre position, so i put the sticks to centre and click ok, then it says, switch tranmitter on,

so i turn the transmitter on, and thats as far as I can get, i have a jr x378 I have it set to ppm mode.

the interface seems fine, as when i plug it into my transmitter it lights up, but the reflex program doesnt appear to be picking it up.

anyone have a solution, maybe Im forgeting something ???
kgfly
03-26-2007, 06:08 AM
On a JR radio you don't need to turn on the power switch on the Tx as this will stop the PPM signal from going to the trainer port. The Tx will automatically power-up when you plug the cable into the trainer port.
harry29
03-26-2007, 06:39 AM
On a JR radio you don't need to turn on the power switch on the Tx as this will stop the PPM signal from going to the trainer port. The Tx will automatically power-up when you plug the cable into the trainer port.

Yeah i tried that one already, but I still end up with the same result, any other suggestions ??
captcasper7
03-26-2007, 03:36 PM
make sure you are using a mono jack plug, like the one in the pic. If you have the stereo (one with two black bands you have the wrong plug)
harry29
03-26-2007, 07:31 PM
make sure you are using a mono jack plug, like the one in the pic. If you have the stereo (one with two black bands you have the wrong plug)

Ok have checked the plug, it has just one band so it is mono
harry29
03-27-2007, 03:44 AM
ok after checking all these suggestions, and no joy, I decided to take the plug off and see if there was a bad connection and sure enough there was.

so it goes just fine now

thanks for all your suggestions guys