asinla
03-26-2007, 07:58 PM
Hello all. I am having a few problems setting up these compnents.
I am using a Berg 6 G III rx with the Telebee gyro and an Airtronics RD6000 Super tx. No matter what I do I cannot get the gyro to initialize. All I get is a blinking blue light. I have opened a completely new model in the RD6000. I have tried holding the rudder full left before plugging in. I have plugged the servo straight into channel4 (rudder/gyro) and get proper servo movement. So I know the servo and tx seem to be ok. But whenever I plug the gyro into channel 4, nothing at all happens. I successfully use this tx with a GWS PG-03 gyro with no problems at all. Any ideas? I am at a complete loss. This is my first HH gyro setup ever and it's not going too well. It's been over a month since I got the helo and I still can't get off the ground.
Thanks very much in advance for any replies.
asinla
I am using a Berg 6 G III rx with the Telebee gyro and an Airtronics RD6000 Super tx. No matter what I do I cannot get the gyro to initialize. All I get is a blinking blue light. I have opened a completely new model in the RD6000. I have tried holding the rudder full left before plugging in. I have plugged the servo straight into channel4 (rudder/gyro) and get proper servo movement. So I know the servo and tx seem to be ok. But whenever I plug the gyro into channel 4, nothing at all happens. I successfully use this tx with a GWS PG-03 gyro with no problems at all. Any ideas? I am at a complete loss. This is my first HH gyro setup ever and it's not going too well. It's been over a month since I got the helo and I still can't get off the ground.
Thanks very much in advance for any replies.
asinla