Tailshaft assembly question

[jmiceli11]

I just replaced the tail shaft on my Logo 14, chasing a vibration, and I flipped the hex that has the pin through it that the pulley slips over. I have the little raised ring facing in, not out. How critical is it for that little raised ring to face out? I have the carbon tail box and it's a real pain to disassemblr and then re-assemble, but I will if it's critical.

Thanks,
John

[Lorents]

Hi John,

I think the pulley might bind against the bearing in the tail box if the raised ring face inwards. Not sure if its critical but I would have turned it around :)

[Klinger]

Yep its meant to face the bearing for support on the inner race. Otherwise it'll probably bind.

[Motions]

Facing out is a must.