Failsafe 7CHP

[Steel Butcher]

I have all channels set to "hold" except Throttle, which I programmed to low (zero) stick.

I assume that this means if the rec. locks out, the throttle stops, however I fly in Idle1 which would have a 90% throttle at low stick ? ? ? ?

[BarracudaHockey]

No it means the throttle will go to idle. Fire up the reciever, give her full throttle and turn off the transmitter and watch what happens, try it in idle up too.

[DavidH]

Only do the above if it is a nitro heli and has a throttle servo <G>
If it is electric do not try the above unless you unplug the wire to the motor.


David

[BarracudaHockey]

Hehe ya good point, I was assuming nitro and an actual throttle servo.

[Steel Butcher]

Thanks.