G90 Great Tip!!!

[flag8r77]

Just read a great tip in the latest RC Heli mag about the BCPP. If your using the G90 try the following, works great. See the attachment for the article.

- Set the Ch.5 on TX to 100%
- Set the gain on the 3:1 to 20-25%
The result is one very straight tail.

[Anubis328]

Does this result in Tail wag? The Blade in the Article was using a Direct Drive tail, and a GWS Motor. I'm still running the stock tail motor. I haven't had trouble with it yet, so I haven't felt the need to replace it.

[flag8r77]

No tail wag, I had to dial the Ch. 5 knob on the TX to about 95%. I am also using a stock tail motor.

[Nyther]

I adjusted the proportional mixing mixing trimmer pot to 30% and left the gain at 0%. Now, were ever I point the nose, it will stay there and I can remove my thumb from the rudder stick and not fight the tail.