pwkpete
08-31-2011, 11:22 AM
Wondering if anyone else has made their own night tail blades...
I have started to build a set, pretty much wired up, but still am a little concerned over the high tail RPM and extra weight (1.5g) offset from the center of the blade. This is on a Logo 600 tail with 2 radial bearings and 1 thrust... I don't think the weight itself is an issue, more the offset.
I do use high strength 3M tape to hold the cell down, then use shrink to press it to the blade so it won't shoot out as I do with my mains.
Anyone with experiences?
I have started to build a set, pretty much wired up, but still am a little concerned over the high tail RPM and extra weight (1.5g) offset from the center of the blade. This is on a Logo 600 tail with 2 radial bearings and 1 thrust... I don't think the weight itself is an issue, more the offset.
I do use high strength 3M tape to hold the cell down, then use shrink to press it to the blade so it won't shoot out as I do with my mains.
Anyone with experiences?