flag8r77
04-17-2007, 04:17 PM
Anyone have any setup info or links to setup for the above radio and heli setup? I am new to computerized TX. Thanks for your help!
Rollingball
04-17-2007, 05:36 PM
I got a MX450 and a 6EXH on the way and would like the same info - :fly
sammy54
04-18-2007, 02:07 PM
i have the same setup ..
NT 0/25/85/91/98
NP 30/53/65/73/95
Swash E-3
A +65
E +65
P +65
EPA
A 130 L/R
E 120 U/D
T 100 U/D
R 100/130 L/R
P 100 U/D
This should get ya in the air.. it works for me .. fine tune later :smokin:
Rollingball
04-18-2007, 04:31 PM
Thanks for the info!! Not many like to disclose there info.
sammy54
04-18-2007, 09:20 PM
no big deal to me we are not competing or anything
kenpsych
05-25-2007, 09:35 PM
seems likes a "dusty" forum...
Steelman
05-31-2007, 10:02 PM
here is what my settings are on my MX450xs, on my 6EXHP,you need to find your own EPA, much info on here how to set up heli,SWSH A+51,E+41,P+57,but you should find your pitch for max,0-at 50% pitch, set your throttle 5 point, 1-0,2-64,3-98,4-99,5-100%...should put you around 3,400RPM head speed, and throw away the fiber glass main blades315mm, and get good Carbon fiber 325mm'...you will like alot better' I am running almost 14 degrees max pitch, but I have much power and don't slow head speed or load motor, I built my own 650 brushed 7.4 volt 44amp with internal cooling fan, run a 2200mAh 2S 20C Lipo, get just over 15min. of flying on charge, before BEC cuts.......not bad for a motor that whays about 4oz....gross flying weight is around 25oz, and at ful pitch it launches like a bottle rocket.....hope this helps, I built my motor out of a $10.00 air compressor 12volt that plugs into car cig lighter, rewrapped it with 20 amp turns on poles,using 22gage high temp 90% pure copper wire....had to open frame alittle to fit in heli, in there' :smokin: